Get Promotion  PCB Prototipyng
Introduction:

The easiest and fastest way to get 5 to 1000 PCBs prototyped for an incredible low price while the production and quality control follows all industrial standards. Bigger quantities up to 100k, special material or surface, up to 20 layers or even flexible boards (FPC) are available on request.

How it works:
Choose your options above.
Verify that your Gerber files comply with all limits and with the sub-board definition below.
Upload your Gerber files.
Add to Cart.
Done.

For bigger quantities, more layers, special options, tests, panels, discounts or combination with our other services contact us directly at [email protected] If you want to go from prototying to real production then visit our Other Services.
Check out PCB fabrication FQA.

Production Time:
2 layer board: 3-4 working days, if qty>50, 4-6 working days.
4 layer board: 4-5 working  days, if qty>50, 5-7 working days.

Expediting Production time:
Contact us if you have any queries regarding delivery. Please don't order 24hours and 48hours production time on Thursday and Friday, there is no enough time for us ship it out before weekend.
If the qty>30 and you choose 24hr, that is mean we will manufacture the boards with 48hr;
If the qty>30 and you choose 48hr, that is mean we will manufacture the boards with 72hr.

Combinations:
If you want more than only a naked PCB you can combine the PCB prototyping service together with our other electrical prototyping services to a turnkey solution:
Gerber Files: If you are ordering the first time make sure that your design is comply with  following min/max limits:
Solder Paste Stencil: the solder paste stencil is Laser-cut steel on a aluminum frame with a minimum recommended pitch of 0.4mm.
Please make sure the effective area is twice as big as your PCB so that top and botom side can be placed on the same stencil.

Separated Sub-Boards: for separating boards please use a slot according to following pictures. Drilling holes or other methods for separating boards will be NOT accepted. Boards which are separated only by silk-screen are not counted as sub-boards and don't have to be payed extra. Junctions between V-Slots are always crossing (X). For other junctions like (T) or (L) you need to use the normal milling and not the V-Slot.

Panels: For higher quantities (depending on the used area) we will combine your PCBs automatically to a panel. If you don not want it or want to define your own panel then contact us before ordering at [email protected]
E-Test: All PCBs are getting a 100% AOI (Automated Optical Inspection) to make sure that all tracks and pads are connected.
In addition to this the PCBs can be tested by a flying probe to make sure that all vias are connected, because this is not visible by the AOI.
1-layer PCBs don't need this tests because there are no vias.
4- and 6-layers will be tested always 100% with a flying probe.
For 2-layer PCBs you have the choice between a 100% E-Test with a flying probe or only to test enough to make sure that at least 95% of all PCBs are working. If you want higher quality  choose always E-Test 100% . If you want a lower price then choose E-Test 95%.

.